|
|
       DELIVERY PROGRAMME:
Gauge O,3 mm. MINIMUM 1,0 mm. MAXIMUM Width: 18 mm.MINIMUM (slit width) 810 mm. MAXIMUM Coils:* Standard widths: 500 mm I.D. Other I.D. available upon request. OD max 1200 mm. depending on gauge + quality. Without core on request. Available with Polyethylene protection tape. * also available for USA, CANADA and MEXICO: 19.5" - 22" - 24.4" - 29" Tolerance on lateral curvature: a) Standards widths to UNI EN 485/4 and to UNI EN 546/3. b) Slit width in 0.4 mm. gauge and above:> 60 mm. width 1.5mm. per 1000 mm. Slit width less than 0,4 mm. gauge to UNI EN 485/4 and to UNI EN 546/3. Tolerance on width a) Standards widths to UNI EN 485/4and to UNI EN 546/3. b) Slit width: -/+ 0,2 mm CUT SHEETS Tolerance on length: +/- 1.5 mm. Tolerance on width: see coil. Squareness tolerance: tension levelled strip: +/- 1.5 mm. non tension levelled strip: +/- 3.0 mm. Available with Polyethylene protection tape. Remarks We cannot guarantee the surface condition, i.e. texture, variable brilliance when employing commercial lower qualities. Appraisal of surface is by visible inspection at approx 1 mt length. We cannot guarantee that the protective tape is free of creases or air bubbles. Because of unavoidable process variation we cannot guarantee the absolute matching of colours. ANOFOL s.r.l. clad with protective film must: 01) Not be exposed to sunlight for any length of time 02) Be stored in a warm dry environment at temperatures not exceeding 28° C. 03) Not be stored outdoors. 04) Not be placed in contact with mineral oils, fats and organic substances 05) Be protected against wetness and humidity. 06) Be protected against mechanical damage. 07) Not be molested, i.e. peeling off the tape partly and then "recladding" by hand. 08) Not be stored longer than 6 months. 09) This must be done evenly. 10) The temperature should be above freezing 
2008-11-12 New slitter 1250 mm - We are pleased to a... 
|